ES 350 V6-3.5L (2GR-FE) (2007)
/Page-798002.png)
a. Using SST, remove the oxygen sensor.
SST 09224-00010
6. REMOVE HEATED OXYGEN SENSOR (for Bank 2)
a. Using SST, remove the oxygen sensor.
SST 09224-00010
INSTALLATION
1. INSTALL HEATED OXYGEN SENSOR (for Bank 2)
a. Using SST, install the heated oxygen sensor.
SST 09224-00010
Torque: 44 N.m (449 kgf.cm, 32 ft.lbf)
NOTE: The torque shown should be used for tightening without using SST. When the SST is used for tightening, the torque should be
calculated based on the length of the SST.
2. INSTALL HEATED OXYGEN SENSOR (for Bank 1)
