ES 350 V6-35L (2GR-FE) (2007) - Seat Belt System Repair Procedures
b. for Passenger seat:
1. Install the floor end of the front seat outer belt assembly with the bolt.
Torque: 42 N.m (428 kgf.cm, 31 ft.lbf)
c. Check if the ELR locks.
NOTE: The check should be performed with the outer belt assembly installed.
1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.
9. INSTALL SEAT BELT ANCHOR COVER CAP
a. Engage the 7 claws to install the seat belt anchor cover cap.
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. PERFORM INITIALIZATION
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal.
12. INSPECT SRS WARNING LIGHT
Rear Seat Inner Belt Assembly