ES 350 V6-3.5L (2GR-FE) (2007)
a. Check the degree of tilt when the ELR begins to lock.
1. Check that the belt does not lock at less than 15° of tilt in any direction but locks at over 45° of tilt while gently pulling the belt.
NOTE: Do not disassemble the retractor.
b. Install the rear seat inner with center belt assembly RH with the bolt.
Torque: 42 N.m (428 kgf.cm, 31 ft.lbf)
2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (W/o Rear Sunshade.
a. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
b. Engage the 2 clips and 6 claws to install the package tray trim panel assembly.
3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (W/ Rear Sunshade)
4. INSTALL CENTER STOP LIGHT SET (W/o Rear Sunshade)
5. INSTALL REAR SEAT SHOULDER BELT HOLE COVER