ES 350 V6-3.5L (2GR-FE) (2007)
a. Release the stopper by pulling the stopper down and disconnect the rain sensor as shown in the illustration.
b. Disconnect the connector and remove the rain sensor.
3. REMOVE RAIN SENSOR TAPE
HINT: This step should be performed only when the rain sensor tape needs to be replaced.
a. Remove the rain sensor tape.
NOTE: The rain sensor tape can be reused, however, replace it with a new one if it is dirty or damaged.
INSTALLATION
1. INSTALL RAIN SENSOR TAPE
NOTE: The rain sensor tape can be reused, however, replace it with a new one if it is dirty or damaged.
HINT: This step should be performed only when the rain sensor tape needs to be replaced.
a. Remove the releasing sheet (yellow side) from new rain sensor tape and apply the tape to the position indicated in the illustration (the sensor
part of the rain sensor) while pushing out air bubbles with your fingers.