ES 350 V6-3.5L (2GR-FE) (2007)
1. INSTALL PLANETARY GEAR
a. Apply high-temperature grease to the planetary gears and pin parts of the planetary shaft.
b. Install the 3 planetary gears to the starter drive housing assembly.
2. INSTALL STARTER ARMATURE ASSEMBLY
a. Apply high-temperature grease to the plate washer and the armature shaft.
b. Install the starter armature assembly to the starter commutator end frame assembly.
c. Using snap ring pliers, install the plate washer and a new snap ring.
d. Using vernier calipers, measure the snap ring.
Maximum length: 5.0 mm (0.197 in.)
If the length is greater than the maximum, replace the snap ring with a new one.
3. INSTALL STARTER COMMUTATOR END FRAME COVER