ES 350 V6-3.5L (2GR-FE) (2007)
(b) Install the power steering control valve sub-assembly into the control valve housing sub-assembly.
NOTICE: Be careful not to damage the power steering control valve spacers and power steering control valve upper oil seal lip.
HINT: Wrap protective tape around the spline of the power steering control valve sub-assembly in order to prevent damage to the oil seal.
12. INSTALL POWER STEERING CONTROL VALVE LOWER OIL SEAL
(a)
Coat a new power steering control valve lower oil seal lip with power steering fluid.
(b) Using SST and a press, install the power steering control valve lower oil seal to the control valve assembly.
SST 09612-22011
NOTICE:
^
Make sure that the power steering control valve lower oil seal is installed in the correct direction as shown in the illustration.
^
Do not damage the power steering control valve lower oil seal.
13. INSTALL POWER STEERING CONTROL VALVE ASSEMBLY
(a)
Install the power steering control valve assembly and a new gasket to the power steering rack housing with the 2 bolts.
Torque: 21 N*m (214 kgf*cm, 16 ft.*lbf)