ES 350 V6-3.5L (2GR-FE) (2007)
reinstalled, the QR code label will be positioned where the code cannot be read. Record the transaxle compensation code BEFORE reinstalling the
automatic transaxle.
14.
After replacement of the transaxle assembly w/torque converter enter the new transaxle compensation code.
Refer to TSIB No. TC002-06, "U660E Automatic Transaxle Compensation Code Input Process".
15.
Install the Authorized Modifications Label.
A.
Using a permanent marker, enter the following information on the label:
^
TCM part number: [Refer to the Parts Information section for the CURRENT PART NUMBER]
^
Calibration ID(s): [Refer to the Calibration Identification Chart for the NEW CALIBRATION ID]
^
Dealer Code
^
Repair Date
^
Change Authority (this TSIB number): TC005-07
B.
Affix the Authorized Modifications Label to the vehicle at the location shown in Figure 1. The Authorized Modifications Label is available
through the MDC, P/N 0045-00001-LBL.
16.
Allow the vehicle to cold soak for a minimum of 4 hours.
17.
Test-drive the vehicle to confirm proper vehicle operation.