ES 350 V6-3.5L (2GR-FE) (2007)
NOTICE:
^
Prevent foreign matter from adhering to the speed sensor.
^
Be careful not to damage the speed sensor.
6. SEPARATE TIE ROD END SUB-ASSEMBLY
(a)
Remove the cotter pin and nut.
(b) Using SST, separate the tie rod end sub-assembly from the steering knuckle.
SST 09628-00011
NOTICE:
^
Make sure that the string of the SST is securely tied to the vehicle.
^
Be careful not to damage the ball joint dust cover.
^
Be careful not to damage the steering knuckle.
^
Be careful not to damage the front disc brake dust cover.
7. SEPARATE FRONT SUSPENSION LOWER NO. 1 ARM
(a)
Remove the bolt and 2 nuts, and separate the front suspension lower No. 1 arm from the lower ball joint.
8. SEPARATE FRONT AXLE ASSEMBLY
(a)
Put matchmarks on the front drive shaft assembly and the axle hub.
(b) Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly.
NOTICE: Be careful not to damage the drive shaft boot or speed sensor rotor.