ES 350 V6-3.5L (2GR-FE) (2007)
a. Clean and shape the contact surface of the vehicle body.
1. Using a knife, cut away any rough adhesive on the contact surface of the vehicle body to ensure the appropriate surface shape.
NOTICE: Be careful not to damage the vehicle body.
HINT: Leave as much adhesive on the vehicle body as possible.
2. Clean the contact surface of the vehicle body with a piece of cloth saturated with cleaner.
HINT: Even if all the adhesive has been removed, clean the vehicle body.
INSTALLATION
1. INSTALL NO. 2 BACK WINDOW GLASS STOPPER
a. Using a brush or sponge, coat the application area of the No. 2 stoppers with Primer G.
NOTICE:
-
Do not apply too much primer.
-
Allow the primer coating to dry for 3 minutes or more.
-
Do not keep any of the opened Primer G for later use.
HINT: If an area other than that specified is coated by accident, wipe off the primer with a clean piece of cloth before it dries.
b. Install 2 new No. 2 stoppers onto the back window glass, as shown in the illustration.
HINT: Only 2-piece type No. 2 stoppers are supplied. Use the 2-piece type stoppers even if a 1-piece type was used.
2. INSTALL NO. 1 BACK WINDOW GLASS STOPPER