GS 300 L6-3.0L (2JZ-GE) (1993)
(c) Using a clip remover, disconnect the clamps.
(d) Remove the wire harness.
23. REMOVE INSIDE PANEL FRAME
Remove four screws and the frame.
REAR DOOR ASSEMBLY
ASSEMBLE REAR DOOR PARTS BY FOLLOWING DISASSEMBLY SEQUENCE IN REVERSE
BEFORE INSTALLING PARTS, COAT THEM WITH MP GREASE
(a) Apply MP grease to the window regulator rollers.
(b) Apply MP grease to the sliding surface of the door lock.
INSTALL REAR DOOR CHECK
(a) Apply adhesive to two screws.
Part No.08833-00070,THREE BOND 1324 or equivalent
(b) Install the door check with two screws.
Torque: 8.8 N.m (90 kgf.cm. 78 in.Ibf)
INSTALL REAR DOOR LOCK
(a) Apply adhesive to two screws.
Part No.08833-00070,THREE BOND 1324 or equivalent
(b) Install the door check with two screws.
Torque: 5.4 N.m (55 kgf.cm, 48 in.Ibf)
(c) Connect the connector.
(d) Install the clamps.