GS 300 L6-3.0L (2JZ-GE) (1993)
/Page-313001.png)
Crankshaft Main Bearing Seal: Service and Repair
Seal Retainer Installed On Engine
1. Using a knife, cut off the oil seal lip.
2. Using a screwdriver, pry out the oil seal.
NOTE: Be careful not to damage the crankshaft. Tape the screwdriver tip.
3. Apply MP grease to a new oil seal lip.
4. Using seal driver Special Service Tool (SST) No. 09223-56010, or equivalent, and a hammer, tap in the oil seal until its surface is flush with the
rear oil seal retainer edge.