GS 300 L6-3.0L (2JZ-GE) (1993)
-
Disconnect the following hoses:
Water bypass hose from water outlet (1)
Water bypass hose from No.2 water bypass pipe (2)
-
Remove the throttle body and gasket.
7. Remove No. 3 timing belt cover.
-
Remove the oil filler cap.
-
Using a 5 mm hexagon wrench. remove the 6 bolts and timing belt cover.
8. Remove cylinder head rear cover. Using a 5 mm hexagon wrench, remove the 4 bolts and rear cover.
9. Remove high-tension cords and cord clamps assembly.
-
Disconnect the 2 high-tension cord clamps from the claws of the No.3 cylinder head cover.
-
Remove the bolt holding the high-tension cord clamp to No.2 cylinder head cover.
-
Disconnect the high-tension cords from the distributor and ignition coil.
-
Using a screwdriver, lift up the lock claw and disconnect the holder from the distributor (ignition coil).