GS 300 L6-3.0L (2JZ-GE) (1993)
-
Install 2 new gaskets and the No. 2 front exhaust pipe to the exhaust manifolds with 4 new nuts.
Torque: 62 Nm (46 ft lb)
-
Install the pipe support bracket to the transmission with the 2 bolts.
Torque: 43 Nm (32 ft lb)
-
Install a new gasket to front end of the front exhaust pipe, and torque the front exhaust pipe to the No. 2 front exhaust pipe.
Torque: 43 Nm (32 ft lb)
Removal - Rear Catalytic Converter
1. Disconnect Sub Heated Oxygen Sensor from front exhaust pipe (Calfornia only).
-
Disconnect the wire grommet from the floor.
-
Remove the 2 bolts and sensor cover.
-
Disconnect the Oxygen Sensor from the exhaust pipe.
2. Remove front exhaust pipe (rear Converter).
-
Remove the 2 bolts holding the front exhaust pipe to the center exhaust pipe.
-
Remove the 2 bolts and nuts holding the front exhaust pipe to the No.2 front exhaust pipe.
-
Remove the front exhaust pipe and 2 gaskets.
Installation - Rear Catalytic Converter