GS 300 L6-3.0L (2JZ-GE) (1993)
Ignition Cable: Service and Repair
Removal
PROCEDURE
1. Disconnect cable from negative terminal of battery.
CAUTION: Turn the Ignition Switch to "LOCK". Disconnect the cable from the negative (-) terminal of the battery. Wait 90 seconds before
proceeding with work.
2. Drain engine coolant.
3. Disconnect the following control cables from Throttle Body;
Accelerator cable (1)
A/T throttle control cable (2)
Cruise control actuator cable (3)
4. Remove intake air connector pipe.
-
Disconnect the following hoses:
Power Steering air hose from air connector pipe (1)
Positive Crankcase Ventilation hose from No. 2 cylinder head cover (2)
-
Loosen the 2 hose clamps, and remove the air connector pipe with the hoses.
5. Remove the 4 nuts, and disconnect the Throttle Body bracket from the Throttle Body and cylinder head.