GS 300 L6-3.0L (2JZ-GE) (1993)
6. Remove Throttle Body.
-
Disconnect the following connectors:
Throttle position sensor connector (1)
Sub-throttle position sensor connector (w/ TRAC) (2)
Sub-throttle actuator connector (w/ TRAC) (3)
Idle Air Control Valve connector (4)
-
Disconnect the following hoses:
4 vacuum hoses (1)
Air hose from intake manifold (California only) (2)
-
Remove the 2 bolts and 2 nuts.
-
Disconnect the water bypass hose (the No. 2 water bypass pipe) from the clamp on the engine hanger.
-
Slightly slide the Throttle Body away from the intake air connector.