GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-1888001.png)
Hood Latch Release Cable: Service and Repair
HOOD LOCK CONTROL CABLE ASSEMBLY
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE ENGINE ROOM SIDE COVER LH
3. REMOVE COOL AIR INTAKE DUCT SEAL
4. REMOVE ENGINE UNDER COVER
5. REMOVE FRONT FENDER LINER LH
6. REMOVE FRONT FENDER LINER RH
7. REMOVE FRONT BUMPER COVER
8. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Cruise Control System)
9. REMOVE HOOD LOCK CONTROL CABLE COVER
a. Remove the 3 screws.
b. Detach the claw and remove the cable cover.
10. REMOVE FRONT FENDER PROTECTOR UPPER LH
a. Using a screwdriver, detach the 3 clips and remove the protector.
HINT: Tape the screwdriver tip before use.
11. REMOVE HOOD LOCK ASSEMBLY
