GS 300 RWD V6-3.0L (3GR-FSE) (2006)
a. Procedures for Test Mode.
(1) Turn the engine switch off.
DLC3
(2) Using SST, connect terminals TS and CG of the DLC3.
SST 09843-18040
Test Mode
(3) Check that the steering wheel is in the straight ahead position and move the shift lever to the P position.
NOTICE: DTC C1210/36 and C1336/39 will be recorded if the shift lever is not in the P position.
b. Obtain the zero point of the yaw rate and acceleration sensor.
(1) Turn the engine switch on (IG).
(2) Keep the vehicle in a stationary condition on a level surface for 2 seconds or more.
(3) Check that the ABS and brake control warning lights blink and VSC TEST MODE is indicated on the multi-information display (Test
Mode).
HINT:
^
If the ABS and brake control warning lights do not blink and VSC TEST MODE is not indicated on the multi information display,
perform zero point calibration again.
^
The zero point calibration is performed only once after the system enters the Test Mode.
^
Calibration cannot be performed again until the stored data is cleared.
c. Turn the engine switch off and disconnect the SST from the DLC3.