GS 300 RWD V6-3.0L (3GR-FSE) (2006)
(3) Check that the VSC warning light blinks and VSC TEST MODE is displayed on the multi information display (test mode).
HINT:
-
If the VSC warning light does not blink and/or VSC TEST MODE is not displayed on the multi information display, perform zero
point calibration again.
-
The zero point calibration is performed only once after the system enters the test mode.
-
Calibration cannot be performed again until the stored data is cleared once.
c. Turn the engine switch off and disconnect the SST from the DLC3.