GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-633005.png)
14. REMOVE WATER PUMP ASSEMBLY
a. Remove the 16 bolts, water pump and gasket.
INSTALLATION
1. INSTALL WATER PUMP ASSEMBLY
a. Install a new gasket and the water pump with the 16 bolts.
Torque: 21 Nm (214 kgf-cm, 15 ft. lbs.) for bolt A 9.1 Nm (93 kgf-cm, 81 inch lbs.) for bolts B and C
NOTICE:
^
Be sure to replace the 2 C bolts with new ones or reuse them after applying adhesive 1344.
^
Make sure that there is no oil on the threads of bolt A.
2. INSTALL NO.2 IDLER PULLEY SUB-ASSEMBLY
a. Install the V-ribbed belt tensioner pulley and cover plate with the bolt.
Torque: 43 Nm (438 kgf-cm, 32 ft. lbs.)
CAUTION: Be careful when tightening the bolt because it is left-hand threaded.
