GS 300 RWD V6-3.0L (3GR-FSE) (2006)
e. Connect the 2 radiator hoses.
4. ADD ENGINE COOLANT
5. CHECK FOR ENGINE COOLANT LEAKS
a. Check for engine coolant leaks.
6. INSTALL WATER PUMP PULLEY
a. Temporarily install the pulley with the 4 bolts.
b. Using SST, hold the pulley and tighten the 4 bolts.
SST 09960-10010 (09962-01000, 09963-00700)
Torque: 21 Nm (214 kgf-cm, 15 ft. lbs.)
7. INSTALL INJECTOR DRIVER
8. INSTALL NO.1 ENGINE COVER
9. INSTALL NO.2 ENGINE COVER
a. Install the cover with the 3 nuts.
10. INSTALL V-RIBBED BELT
11. INSTALL V-BANK COVER SUB-ASSEMBLY
a. Install the cover with the 2 nuts.
Torque: 5.0 Nm (51 kgf-cm, 44 ft. lbs.)
12. INSTALL NO.1 AIR CLEANER INLET
a. Install the inlet with the bolt.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
13. INSTALL COOL AIR INTAKE DUCT SEAL
14. INSTALL ENGINE UNDER COVER
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
16. PERFORM INITIALIZATION
a. Perform initialization.
NOTICE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.