GS 300 RWD V6-3.0L (3GR-FSE) (2006)
B.
Remove the timing chain from the timing gear, and slide the No. 3 camshaft (with the No. 2 chain) out toward the rear of the vehicle.
NOTE
Keep tension on the timing chain to avoid separation from the crankshaft timing gear.
C.
Tie the timing chain to the oil pipe with a strap.
35.
Remove and replace the Bank 1 intake camshaft gear assemblies.
A.
Clamp the hexagonal portion of the camshaft in a vice and remove the bolt.
B.
Install the NEW intake camshaft gear assemblies and torque the bolt.
Torque: 100 N*m (1020 kgf*cm, 74 ft*lbf)
C.
Repeat for the Bank 2 intake camshaft gear assembly.
Repair Procedure: Reassembly
1.
Install the No. 3 camshaft.
A.
Align the mark plate (yellow) of the No. 2 chain with the timing marks of the camshaft timing gear assembly shown in the illustration.
B.
Clean the camshaft journals and apply engine oil.