GS 300 RWD V6-3.0L (3GR-FSE) (2006)
Standard Upper Bearing Center Wall Thickness (No. 1 and No. 4 Journal) (part 2)
Standard Lower Bearing Center Thickness (No. 1 and No. 4 Journal)
Standard Upper Bearing Center Thickness (No. 2 and No. 3 Journal)
Standard Lower Bearing Center Thickness (No. 2 and No. 3 Journal)
Inspect for circle runout.
Place the crankshaft on the V-blocks.
Using a dial indicator, measure the circle runout at the center journal.
Maximum circle runout: 0.06 mm (0.0024 inch)
If the circle runout is greater than the maximum, replace the crankshaft.
Inspect the main journals.
Using a micrometer, measure the diameter of each main journal.