GS 300 RWD V6-3.0L (3GR-FSE) (2006)
9. Install the injector driver with the bolt and 2 nuts.
Torque: 10 N*m (102 kgf*cm, 7 ft*lbf)
10. Install the No.1 engine cover with the 3 clips.
11. Install the cylinder head cover RH.
A. Apply FIPG sealant as shown in the illustration. FIPG sealant: P/N 08826-00080 (or equivalent)
NOTE
^
Remove any oil from the contact surface.
^
Install the head cover within 3 minutes after applying the FIPG sealant.
^
Do NOT start the engine for at LEAST 2 hours after installing.