GS 300 RWD V6-3.0L (3GR-FSE) (2006)
Condenser HVAC: Service and Repair
REMOVAL
1. REMOVE COOL AIR INTAKE DUCT SEAL
2. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
4. REMOVE ENGINE ROOM SIDE COVER RH
5. REMOVE ENGINE ROOM SIDE COVER LH
6. REMOVE NO. 1 AIR CLEANER INLET
7. REMOVE FRONT BUMPER COVER
8. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)
9. REMOVE RADIATOR SUPPORT OPENING COVER
10. REMOVE HOOD LOCK CONTROL CABLE COVER
11. REMOVE HOOD LOCK ASSEMBLY
12. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY
a. Using a clip remover, detach the 6 clamps and remove the wire harness.