GS 300 RWD V6-3.0L (3GR-FSE) (2006)
a. Loosen the 2 bolts on the bottom side of the condenser.
b. Remove the 2 bolts and cooler condenser.
INSTALLATION
1. INSTALL COOLER CONDENSER ASSEMBLY
a. Install the cooler condenser with the 4 bolts.
Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)
HINT: If the condenser is replaced with a new one, add compressor oil to the new condenser.
Capacity: 40 cc (1.4 fl. oz.)
Compressor oil: ND-8 or equivalent
2. INSTALL DISCHARGE HOSE SUB-ASSEMBLY
a. Remove the vinyl tape attached to the pipe and connecting part of the cooler condenser.
b. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.
Compressor oil: ND-OIL 8 or equivalent
c. Install the O-ring on the discharge hose.
d. Install the discharge hose on the cooler condenser with the bolt.
Torque: 5.4 N.m (55 kgf.cm, 47 in.lbf)
3. INSTALL LIQUID TUBE SUB-ASSEMBLY A