GS 300 RWD V6-3.0L (3GR-FSE) (2006)
d. Set the wheel disc to the mounting machine and install the lower tire bead. Position the main body of the sensor in the shaded area as shown in
the illustration.
NOTICE: If the sensor is positioned outside this area, it generates interference with the tire bead, and may cause damage to the sensor.
e. Install the upper bead.
NOTICE: Make sure that the tire bead and tool do not interfere with the main body of the sensor and that the sensor is not clamped by the
bead.
5. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
6. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
7. INSPECT TIRE
8. REGISTRATION OF TRANSMITTER ID
9. INSPECT TIRE PRESSURE WARNING SYSTEM
SST 09843-18040
DISPOSAL
HINT: The tire pressure monitor valve sub-assembly is powered by a lithium battery. When disposing of the tire pressure sensor sub-assembly,
remove the battery and dispose of it correctly.
1. DISPOSE OF THE TIRE PRESSURE MONITOR VALVE SUB-ASSEMBLY
a. Use the tip of a screwdriver to pry off the back cover.