GS 300 RWD V6-3.0L (3GR-FSE) (2006)
Tail Lamp: Service and Repair
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT
3. REMOVE TOOL BOX
4. REMOVE REAR FLOOR FINISH PLATE
5. REMOVE LUGGAGE COMPARTMENT TRIM COVER SIDE RH
6. REMOVE LUGGAGE COMPARTMENT TRIM COVER SIDE LH
7. REMOVE LUGGAGE COMPARTMENT TRIM COVER FRONT
8. REMOVE REAR COMBINATION LIGHT ASSEMBLY
a. Disconnect the connector.
b. Remove the 3 nuts and rear combination light.
c. Remove the rear combination light bulb from the rear combination light socket and wire subassembly.
d. Remove the gasket.
NOTE:
-
Be sure to remove the gasket completely from the body.
-
Be sure to replace it with the supplied rear combination light gasket to prevent water intrusion.
9. REMOVE REAR LIGHT ASSEMBLY
a. Disconnect the connector.