GS 300 RWD V6-3.0L (3GR-FSE) (2006)
Alignment: Service and Repair
Rear Wheel Alignment
REAR WHEEL ALIGNMENT
ADJUSTMENT
1. INSPECT TIRES
2. MEASURE VEHICLE HEIGHT
NOTICE: Before inspecting wheel alignment, adjust vehicle height to the specified value.
3. INSPECT TOE-IN
Toe-In
If the toe-in is not within the specified range, inspect the suspension parts and replace if necessary.
4. ADJUST TOE-IN
a. Loosen the toe adjust cam nut.
b. Turn the adjust cams by an equal amount to adjust toe-in.
HINT:
^
Try to adjust the toe-in to the center value.
^
The toe-in will change by the following specifications corresponding to each graduation of the cam. Approximately 4.0 mm (0.16 inch)
c. Tighten the nut.
Torque: 50 Nm (510 kgf-cm, 37 ft. lbs.)
5. INSPECT CAMBER
a. Install a camber-caster-kingpin gauge or put the wheels on a wheel alignment tester.
b. Inspect the camber.
CAMBER (3GR-FSE)