GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-448004.png)
b. Depress the brake pedal several times, then loosen the bleeder plug with the pedal depressed.
c. When fluid stops coming out, tighten the bleeder plug, then release the brake pedal.
d. Repeat (b) and (c) until all the air in the fluid is completely bled out.
e. Using SST, tighten the bleeder plug completely.
SST 09023-00101
Torque: 11 Nm (112 kgf-cm, 8 ft. lbs.)
f.
Repeat the above procedures for other wheel to bleed the air from the brake line.
6. BLEED REAR BRAKE SYSTEM
NOTICE: Bleed the air by following the steps displayed on the intelligent tester.
a. Turn the engine switch off.
b. Install the 2 ABS motor relays to the engine room relay block No.3.
NOTICE: Install ABS motor relays before bleeding the air from the rear brake system.
c. Turn the engine switch on (IG) and turn the intelligent tester on.
d. Cancel DISABLE BRAKE CONTROL on the intelligent tester.
HINT: If the brake control has been disabled brake control.
e. Clear the DTC.
f.
Turn the intelligent tester on and select DIAGNOSTIC MENU -> ABS/VSC -> ECB UTILITY -> ECB INVALID.
g. With the brake pedal depressed, bleed the bleeder plug on the rear disc brake cylinder LH.
NOTICE: Keep the fluid inside the reservoir above the LOW level by replenishing.
HINT:
^
Depress and hold the brake pedal.
^
After the solenoid operates for approximately 30 seconds, release the brake pedal to stop the solenoid
^
Repeat the procedures until air is completely bled from the rear brake system.
^
The ECB warning light comes on and the buzzer sound while bleeding, but they do not indicate a malfunction.
h. Tighten the bleeder plug after bleeding.
SST 09023-00101
Torque: 11 Nm (112 kgf-cm, 8.0 ft. lbs.)
i.
With the brake pedal depressed, bleed the bleeder plug on the rear disc brake cylinder RH.
NOTICE: Keep the fluid inside the reservoir above the LOW level by replenishing.
HINT:
^
Depress and hold the brake pedal.
^
After the solenoid operates for approximately 30 seconds, release the brake pedal to stop the solenoid.
^
Repeat the procedures until air is completely bled from the rear brake system.
^
The ECB warning light comes on and the buzzer sound while bleeding, but they do not indicate a malfunction.
j.
Tighten the bleeder plug after bleeding.
Torque: 11 Nm (112 kgf-cm, 8.0 ft. lbs.)
SST 09023-00101
k. Cancel DISABLE BRAKE CONTROL on the intelligent tester.
7. PERFORM ACCUMULATOR ZERO DOWN
