GS 300 RWD V6-3.0L (3GR-FSE) (2006)
4. REMOVE FAN AND GENERATOR V BELT
a. While releasing the belt tension by turning the belt tensioner counterclockwise, and remove the V belt from the belt tensioner.
b. While turning the belt tensioner counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the
belt tensioner.
INSTALLATION
1. INSTALL FAN AND GENERATOR V BELT
a. Install the V belt.
b. While turning the belt tensioner counterclockwise, remove the bar.
NOTICE:
^
Put the backside of the V belt on the tensioner pulley and idler pulley.
^
Check that the drive belt is properly set to each pulley.
c. If it is difficult to install the V belt, perform the following procedure.
(1) Put the V belt on everything except the tensioner pulley as shown in the illustration.