GS 300 RWD V6-3.0L (3GR-FSE) (2006)
a. Disconnect the sensor connector.
b. Remove the grommet and pass the sensor connector out of the cabin through the floor panel.
c. Using SST, remove the sensor from the front exhaust pipe.
SST 09224-00010
10.
REMOVE CONSOLE BOX REGISTER ASSEMBLY (for 4WD)
11.
REMOVE CONSOLE BOX (for 4WD)
12.
DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY (for 4WD)
13.
REMOVE FRONT SEAT ASSEMBLY
14.
REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2 of 4WD)
a. Disconnect the sensor connector.
b. Remove the grommet and pass the sensor connector out of the cabin through the floor panel.
SST 09224-00010
INSTALLATION
1. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2 of 4WD)