GS 300 RWD V6-3.0L (3GR-FSE) (2006)
b. Install the 2 nuts.
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
NOTE: Be sure to first tighten the nut on the vehicle rear.
c. Connect the ECM connectors.
1. Connect the 6 ECM connectors.
NOTE: Be sure to securely connect the connector.
2. Connect the No. 4 connector holder to the ECM box.
2. INSTALL ECM COVER
a. Install the ECM cover with the 3 bolts.
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
NOTE: Make sure that the wire harness does not get caught between the parts.
3. INSTALL ENGINE ROOM SIDE COVER LH
a. Install the side cover with the 3 clips.
4. INSTALL COOL AIR INTAKE DUCT SEAL
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL