GS 300 RWD V6-30L (3GR-FSE) Secondary Injector Control Module
Secondary Injector Control Module: Service and Repair
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE AIR CLEANER INLET
a. Remove the bolt and air cleaner inlet.
4. REMOVE NO.1 ENGINE COVER
a. Disconnect the 4 connectors.
b. Remove the 3 clips and cover.
5. REMOVE INJECTOR DRIVER
a. Remove the bolt, 2 nuts and injector driver.
NOTE: Be careful not to drop or strike the injector driver.
INSTALLATION
1. INSTALL INJECTOR DRIVER
NOTE:
-
Be careful not to drop or strike the injector driver.