GS 300 RWD V6-3.0L (3GR-FSE) (2006)
1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a. Measure resistance according to the value(s) in the table when the shift lever is moved to each position.
Standard Resistance
ADJUSTMENT
1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a. Loosen the bolt of the park/neutral position switch and move the shift lever to the N position.
b. Align the groove and the neutral basic line.
c. Hold the switch in position and tighten the bolt.
Torque: 13 Nm (1133 kgf-cm, 10 ft. lbs.)
d. After adjustment, perform the resistance inspection.
INSTALLATION
1. INSTALL NEUTRAL START SWITCH ASSEMBLY
a. Install the park/neutral position switch to the manual valve shaft.
b. Temporarily install the bolt.