GS 300 RWD V6-3.0L (3GR-FSE) (2006)
NOTE: Be careful that the O-ring is not cracked or jumped when installing the oil control valve.
c. Connect the camshaft timing oil control valve connector.
2. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE (for Bank 2 Intake Side)
a. Apply a light coat of engine oil to a new O-ring of the oil control valve.
b. Install the oil control valve with the bolt.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
NOTE: Be careful that the O-ring is not cracked or jumped when installing the oil control valve.
c. Connect the oil control valve connector.
3. INSTALL INTAKE AIR SURGE TANK
4. CONNECT COLD START FUEL INJECTOR ASSY
5. CONNECT VENTILATION HOSE
6. INSTALL ENGINE REAR COVER
7. CONNECT HEATER WATER OUTLET HOSE
8. CONNECT HEATER WATER INLET HOSE
9. CONNECT UNION TO CHECK VALVE HOSE
10. CONNECT WATER BY-PASS HOSE
11. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
12. CONNECT NO. 2 VENTILATION HOSE
13. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE (for Bank 1 Intake Side)
a. Apply a light coat of engine oil to a new O-ring of the oil control valve.