GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-927002.png)
Required SSTs
Repair Procedure
1.
Using the Diagnostic Tester, check for Diagnostic Trouble Codes (DTCs).
If DTCs P043E, P043F, P2401, P2402, and P2419 are ALL present, refer to the Technical Information System (TIS):
^
2006 model year GS 300 Repair Manual: 3GR-FSE Engine Control System: SFI System: U0001, EVAP System
^
2006 model year GS 430 Repair Manual: 3UZ-FE Engine Control System: SFI System: U0001, EVAP System
2.
Replace the charcoal canister assembly if the EVAP pump module is diagnosed in the EVAP Inspection Procedure as the suspected area.
3.
Using the Diagnostic Tester, clear all DTCs.
4.
Perform the Automatic EVAP System Check and verify that NO pending DTCs set.
NOTE:
If the Automatic EVAP System Check fails to run, perform the following:
^
Turn the engine switch OFF.
^
Turn the Diagnostic Tester OFF.
^
Turn the engine switch ON and the Diagnostic Tester ON and restart the Automatic EVAP System Check.
