GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-1024001.png)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE ENGINE ROOM SIDE COVER RH
4. REMOVE ENGINE ROOM SIDE COVER LH
5. REMOVE NO. 1 AIR CLEANER INLET
a. Remove the bolt and air cleaner inlet.
6. REMOVE V-BANK COVER
a. Remove the 2 nuts and V-bank cover.
7. REMOVE FAN AND GENERATOR V-BELT
8. REMOVE ENGINE UNDER COVER
a. Using a clip remover, remove the 3 clips.
b. Remove the 10 screws and under cover.
9. DISCONNECT COMPRESSOR WITH PULLEY ASSEMBLY
10. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the sensor connector.
b. Remove the bolt and sensor.
