GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-707004.png)
7. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
a. Using SST, install the sensor to the exhaust pipe front.
SST 09224-00010
Torque:
40 N.m (408 kgf.cm, 30 ft.lbf) for use with SST
44 N.m (449 kgf.cm, 32 ft.lbf) for not use without SST
HINT: Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
b. Pass the sensor connector through the floor panel and install the grommet.
c. Connect the sensor connector.
8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
9. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
10. INSTALL CONSOLE BOX PLATE
11. INSTALL FRONT ASH RECEPTACLE ASSEMBLY
12. INSTALL CONSOLE UPPER PANEL GARNISH FRONT
13. INSTALL FRONT LH FLOOR COVER
a. Install the cover with the 3 clips.
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
15. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
