GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-735001.png)
Ignition Switch: Service and Repair
Removal and Installation
ENGINE SWITCH
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.
2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH
3. REMOVE FRONT CONSOLE UPPER PANEL ASSEMBLY
4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
5. REMOVE FRONT DOOR SCUFF PLATE LH
6. REMOVE FRONT DOOR OPENING TRIM COVER LH
7. REMOVE INSTRUMENT SIDE PANEL LH
8. REMOVE INSTRUMENT PANEL NO. 1 SAFETY PAD SUB-ASSEMBLY
9. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
10. REMOVE INSTRUMENT PANEL NO. 1 UNDER COVER SUB-ASSEMBLY
11. REMOVE ENGINE SWITCH
a. Disconnect the switch connector.
b. Detach the 2 claws and remove the switch.
INSTALLATION
1. INSTALL ENGINE SWITCH
a. Attach the 2 claws and install the switch.
b. Connect the switch connector.
