GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-1675045.png)
f.
Install the SST.
1. Connect the SST connector.
SST 09082-00700
NOTE: To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the twin lock. Also, secure some
slack for the SST wire harness inside the tire.
g. Deploy the airbag.
1. Connect the red clip of the SST to the battery positive (+) terminal and the black clip of the SST to the battery negative (-) terminal.
2. Check that no one is within a 10 m (33 ft) radius of the tire which the rear seat airbag assembly is tied to.
3. Press the SST activation switch and deploy the airbag.
CAUTION: When deploying the airbag, make sure that no one is near the tire.
HINT: The airbag is deployed as the LED of the SST activation switch comes on.
h. Dispose of the rear seat airbag assembly.
CAUTION:
-
The rear seat airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after
deployment.
-
Use gloves and safety glasses when handling a rear seat airbag assembly with a deployed airbag.
-
Do not apply water, etc. to a rear seat airbag assembly with a deployed airbag.
-
Always wash your hands with water after completing the operation.
1. Remove the rear seat airbag assembly from the tire.
2. Place the rear seat airbag assembly in a plastic bag, tie it tightly and dispose of it as other general part disposal.
