GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-1728002.png)
b. Disconnect the pretensioner connector as shown in the illustration labeled A.
c. Disconnect the tension reducer connector labeled B.
d. Disconnect the pre-collision safety connector labeled C.
e. Remove the 2 bolts and seat belt.
9. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
a. Remove the bolt.
b. Rotate the adjuster approximately 90 degrees. Then pull and remove it.
INSTALLATION
HINT: The installation procedures are the removal procedures in reverse order.
