GS 300 RWD V6-3.0L (3GR-FSE) (2006)
DLC3
4. CLEAR ZERO POINT CALIBRATION (WHEN USING SST CHECK WIRE:)
a. Turn the engine switch on (IG).
b. Using SST, connect and disconnect terminals TS and CG of the DLC3 4 times or more within 8 seconds.
SST 09843-18040
c. Check that the multi information display indicates the normal system code.
d. Remove the SST from the terminals of the DLC3.
e. Using a check wire, perform zero point calibration of the yaw rate and acceleration sensor.
5. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR (WHEN USING SST CHECK WIRE:)
NOTICE:
-
While obtaining the zero point, do not vibrate the vehicle by tilting, moving or shaking it and keep it stationary . (Do not start the engine.)
-
Be sure to do this on a level surface (with an inclination of less than 1 degree).
a. Procedures for test mode.
(1) Turn the engine switch off.
DLC3
(2) Using SST, connect terminals TS and CG of the DLC3.
SST 09843-18040
(3) Check that the steering wheel is centered and move the shift lever to the P position.
NOTICE: DTC C1210/36 and C1336/39 will be recorded if the shift lever is not in the P position.
b. Obtain the zero point of the yaw rate and acceleration sensor.
(1) Turn the engine switch on (IG).
(2) Keep the vehicle stationary on a level surface for 2 seconds or more.