GS 300 RWD V6-3.0L (3GR-FSE) (2006)
4. Disconnect the negative (-) lead from the starter body. Check that the clutch pinion gear returns inward.
If the result is not as specified, replace the starter assembly.
b. Perform operation test without load.
1. Connect the lead wire to terminal C with the nut.
Torque: 9.8 N.m (100 kgf.cm, 87 in.lbf)
2. Mount the starter in a vise.
3. Connect the battery and ammeter to the starter as shown in the illustration.
4. Check that the starter rotates smoothly and steadily while the pinion gear is moving out. Then measure the current.
Specified current: 90 A or less at 11.5V
If the result is not as specified, replace the starter assembly.