GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-1475008.png)
Torque: 76 Nm (775 kgf-cm, 56 ft. lbs.)
NOTICE:
^
Use SST09922-10010 following the direction shown in the illustration.
^
Use a torque wrench with a fulcrum length of 345 mm (13.58 inch)
HINT: Using SST, hold the steering rack and install the steering rack end sub-assembly
d. Using a brass bar and a hammer, stake the 2 claw washers.
NOTICE: Avoid any impact to the steering rack.
2. INSTALL STEERING RACK BOOT NO. 1
a. Apply silicon grease to the inside of the small opening of the steering rack boot No. 1 (LH side).
b. Temporarily install a new steering rack boot No. 1 clamp to the large opening of the steering rack boot No. 1 (LH side) at the position shown
by arrow (A).
NOTICE:
^
Use a new steering rack boot No. 1 clamp.
^
Do not expand the steering rack boot No. 1 clamp more than necessary for installation.
^
Do not deform the steering rack boot No. 1 clamp.
^
Tightening force of the steering rack boot No. 1 clamp becomes uneven if it is installed after being expanded as shown in the illustration.
As a result, rust is caused by water entering from the clearance between the boot and rack housing, causing a malfunction.
^
Use only the supply parts which are applicable to the vehicle to secure the boot.
