GS 300 RWD V6-3.0L (3GR-FSE) (2006)
5. TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
a. Insert the bolt from the rear of the vehicle, and install the front shock absorber lower side on the front suspension lower arm. Temporarily
tighten the nut while holding the bolt.
6. CONNECT FRONT STABILIZER LINK ASSEMBLY
7. CONNECT TIE ROD ASSEMBLY
8. CONNECT SPEED SENSOR FRONT
9. CONNECT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY FRONT
10. STABILIZE SUSPENSION
11. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
a. Fully tighten the bolt on the lower side of the front shock absorber while holding the nut.
Torque: 157 Nm (1,600 kgf-cm, 116 ft. lbs.)
12. FULLY TIGHTEN FRONT SUSPENSION LOWER ARM
a. Fully tighten the bolt on the front of the front suspension lower arm.
Torque: 135 Nm (1,377 kgf-cm, 100 ft. lbs.)
b. Fully tighten the installation nut of the lower arm No. 2 bracket sub-assembly
Torque: 113 Nm (1,152 kgf-cm, 83 ft. lbs.)
13. INSTALL ENGINE UNDER COVER