GS 300 RWD V6-3.0L (3GR-FSE) (2006)
Ride Height Sensor: Service and Repair
HEIGHT CONTROL SENSOR
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE HEIGHT CONTROL SENSOR SUBASSEMBLY FRONT
a. Remove the front tire.
b. Disconnect the connector.
c. 2WD:
Remove the nut and sensor link from the lower arm.
d. 4WD:
Remove the bolt and sensor link from the lower arm.
e. Remove the 2 bolts and sensor.
3. REMOVE HEIGHT CONTROL SENSOR SUBASSEMBLY REAR
a. Remove the rear tire.
b. Disconnect the connector.