GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-1519008.png)
c. Tighten the lock nut.
Torque: 18 Nm (184 kgf-cm, 13 ft. lbs.)
d. Tighten the 2 bolts.
Torque: 21 Nm (214 kgf-cm, 16 ft. lbs.)
2. INSTALL ABSORBER CONTROL ACTUATOR
a. Check that the control rod of the rear shock absorber is in the position shown in the illustration.
NOTICE: If the control rod is not in the position shown in the illustration, turn the control rod to adjust the position and install the absorber
control actuator.
b. Install the absorber control actuator to the actuator support bracket. Turn the actuator clockwise approximately 40° until a click is felt.
NOTICE: Do not excessively turn the actuator.
3. INSTALL REAR SHOCK ABSORBER CAP
