GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-1526009.png)
26. INSTALL REAR AXLE SHAFT NUT
a. Using a chisel and a hammer, stake the axle shaft nut.
27. STABILIZE SUSPENSION
28. FULLY TIGHTEN UPPER CONTROL ARM ASSEMBLY REAR NO. 1
a. Fully tighten the upper control arm assembly rear No. 1 with the nut.
Torque: 161 Nm (1,642 kgf-cm, 119 inch lbs.)
29. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO. 1
a. Fully tighten the rear suspension arm assembly No. 1 with the bolt and nut.
Torque: 95 Nm (969 kgf-cm, 70 ft. lbs.)
NOTICE: Turn the bolt while holding the nut.
30. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO. 2
a. Fully tighten the rear suspension arm assembly No. 2 with the bolt and nut.
Torque: 161 Nm (1,642 kgf-cm, 119 inch lbs.)
NOTICE: Turn the bolt while holding the nut.
31. INSTALL REAR TIRE
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
32. INSPECT PARKING BRAKE PEDAL TRAVEL
33. ADJUST PARKING BRAKE PEDAL TRAVEL
34. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
35. CHECK ABS SPEED SENSOR SIGNAL
