GS 300 RWD V6-3.0L (3GR-FSE) (2006)
a. Put matchmarks on both flanges.
b. Remove the 4 nuts, bolts and washers.
HINT: If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to
separate the propeller shaft assembly from the differential companion flange.
c. Remove the 2 bolts, 2 center support bearing washers and center support bearing.
d. Insert SST in the transmission to prevent oil leakage.
SST 09325-40010
NOTICE: Be careful not to damage the oil seal.
DISASSEMBLY
1. REMOVE PROPELLER SHAFT ASSEMBLY
a. Put matchmarks on both flanges.