GS 300 RWD V6-3.0L (3GR-FSE) (2006)
5. INSPECT SPIDER BEARING
a. Check that the spider bearing rotates smoothly.
b. Check that there is no play in the spider bearing.
HINT: If necessary, replace the intermediate shaft.
6. INSPECT CENTER SUPPORT BEARING ASSEMBLY NO. 1
a. Turn the center support bearing by hand in the rotating direction. Check the center support bearing turns smoothly.
b. Check that the seals are not cracked or damaged.
HINT: If the center support bearing is damaged, worn, or does not turn smoothly, replace it.
REASSEMBLY
1. INSTALL CENTER SUPPORT BEARING ASSEMBLY NO. 1
a. Using SST and a press, install a new sliding shaft dust cover.
SST 09316-60011 (09316-00011)
NOTICE: Be careful not to damage the sliding shaft dust cover.
b. Set the center support bearing assembly No. 1 and 2 center support bearing washers on the intermediate shaft assembly, as shown in the
illustration.